No doubt that, power electronics plays an important role in the modern industry and power system networks.This paper presents the performance analysis of a multi-source, single-output, buck-boost dc-ac convertersuitable for use in different applications such as feeding ac loads from…

In this paper, instantaneous reactive power theory (P-q theory) based control method is proposed forthree-phase four-wire shunt active power conditioner (shunt APC) to mitigate some power qualityproblems namely, harmonic, reactive power, balancing the load currents, and elimination of neutralcurrent. The…

In this paper, the Tent map is analyzed as a source of pseudorandom bits. To evaluate the performance ofthe proposed pseudorandom bit generator, different issues were considered, such as the period length, thediscriminator value and the merit factor. The Tent…

The paper presents a quality of service aware routing protocol which provides low latency for high priority packets. Packets are differentiated based on their priority by applying queuing theory. Low priority packets are transferred through less energy paths. The sensor…

Multiple Input Multiple Output (MIMO) has become one of the most exciting fields in modern engineering. It is mainly used to increase data rate and capacity of wireless communication system. In this paper, we exploit the space and time diversity…

In the past decade several studies on the passive techniques of heat transfer augmentation have been reported. The present paper is a review on progress with the passive augmentation techniques in the recent past and will be useful to designers…

This paper is to design PID controller to supervise and control the speed response of the DC motor and MATLAB program is used for calculation and simulation PID controllers are widely used in a industrial plants because of their simplicity…

This paper presents an optimization based technique for calculation of reactive power flow under line outage condition. Traditional sensitivity based method provides an approximate solution due to presence of non-linearity. This deficiency has been overcome by formulating line outage as…

Wind power plants often located in remote areas are characterized by weak grids and they are frequently subjected to power system disturbance like voltage sag, short circuit fault and dynamic loading. This paper presents a study of the dynamic performance…

The increasing private sectors are focusing employment of eco friendly renewable/green power technologies like PV Cells, Fuel Cells, Wind turbine to meet the growing power demand. This paper presents the analysis and operation of PV system using Multilevel DC to…