The paper presents the simulation results and evaluates the efficiency of constraint base routing algorithms used in MPLS network from the point of their usability in Next Generation Networks. The efficiency of constraint based routing is evaluated according following criteria:…

The goal of this paper is to optimize a measurement methodology for the most accurate broadband modelling of characteristic impedance and other parameters for twisted pairs. Measured values and theirs comparison is presented in this article. Automated measurement facility was…

This paper deals with video transmission over lossy communication networks. The main idea is to develop video concealment method for information losses and errors correction. At the beginning, three main groups of video concealment methods, divided by encoder/decoder collaboration, are…

Hierarchical system of network nodes is suitable solution how to collect and how to pre-process data from large amount of end-nodes. By contrast to flat (one layer) architecture there are special intermediary nodes used and they are called summarization nodes.…

This paper compares today’s most common frame-based classifiers. These classifiers can be divided into the two main groups – generic classifiers which creates the most probable model based on the training data (for example GMM) and discriminative classifiers which focues…

The paper concerns with a throughput of securing process which cannot be described neither by a constant value of bits per second nor by a constant value of packets per second over the range of packet sizes. We propose general…

In this paper an analytical sizing-design procedure for a typical permanent magnet flux-switching machine (PMFSM) with 12 stator and respectively 10 rotor poles is presented. An optimal design, based on Hooke-Jeeves method with the objective functions of maximum torque density,…

In this paper, a Dynamic Voltage Restorer (DVR) without any energy storage devices is proposed to compensate network voltage during disturbances. This DVR utilizes a matrix converter in its topology which eliminates the DC-link capacitor of conventional DVR. The modulation…

In this paper, a new method for uncertainty analysis in fuzzy state estimation is proposed. The uncertainty is expressed in measurements. Uncertainties in measurements are modelled with different fuzzy membership functions (triangular and trapezoidal). To find the fuzzy distribution of…

In order to gain an improvement of safety or availability measures of the safety-relevant control system through employment of redundancy a redundant system has to comply with the requirement on independence of redundant parts. If the requirements on the independence…