| Título: | Performance of Light Emitting Diode on Surface Machined Heat Sink |
| Autores: |
Shanmugan, S.; Universiti Sains Malaysia Mutharasu, D.; Universiti Sains Malaysia Zeng Yin, O.; Universiti Sains Malaysia |
| Fecha: | 2012-10-11 |
| Publicador: | International journal of power electronics and drive systems |
| Fuente: |
 |
| Tipo: |
info:eu-repo/semantics/article info:eu-repo/semantics/publishedVersion |
| Tema: | No aplica |
| Descripción: | In the point of efficient heat removal from light emitting diode (LED) package to ambient, the surface of the heat sinks must be finished based on required condition. The surface finishing plays an important role in efficient heat dissipation. In our work, the top surface of heat sink was machined like two different shapes (slotted and ‘W’ shaped) and tested the thermal performance for 3W green LED. The total thermal resistance was high for ‘W’ shaped surface at 100 mA. Surface modification was not influenced much on the thermal resistance (Rth) value at higher operating current. Noticeable increase on junction temperature was observed for ‘W’ shaped surface at 100 mA than slotted surface. In optical properties, low lux values were recorded for ‘W’ shaped surface at all operating current. In addition, ‘W’ shaped surface showed low value in CRI than other two surfaces (plain and slotted). The observed CCT value was decreased as the measuring time increased. High value in CCT was observed for ‘W’ shaped surface at higher operating current (> 350mA). Slotted surface showed good performance on both thermal and optical properties of the given 3W green LED. |
| Idioma: | Inglés |
1 Simulation of a Transient Fault Controller for a Grid Connected Wind Farm with Different Types of Generators por Abdel-Mageed, Helmy Mohammed; Helwan University,Sharaf, S.M.,El_masry, S.M.,El_harony, M.; Helwan University | 6 Performance Comparison of Starting Speed Control of Induction Motor por Kusbianto, Deddy |
2 Unified Power Quality Conditioner for voltage sag and harmonic mitigation of nonlinear loads por Latha, Y. Kusuma; Lakireddy Balireddy College of Engineering (Autonomous),Saibabu, Ch.; University College of Engineering (Autonomous),Obulesu, Y P; Lakireddy Balireddy College of Engineering(Autonomous) | 7 Fault Tolerant Control in Z-Source Inverter Fed Induction Motor por Rabi, B. Justus |
3 Dynamic Testing & Simulation of 4 KW (5.5 Hp) Switched Reluctance Motor using PSpice por Autee, Rajesh Murlidharrao; Marathwada Shikshan Prasarak Mandal's Deogiri Technical Campus for Engineeing & Mgt Studies, Aurangabad. Aff-Dr. B.A.M.University, Aurangabad-India. | 8 Hysteresis Current Control technique based on Space Vector Modulation for Active Power Filter por Yun-liang, Wang,Qi-liang, Guo |
4 A Review of Voltage and Current Signature Diagnosis in Industrial Drives por Kumar, K. Vinoth | 9 A Novel method of Starting Induction Motor - A Comparative Study por Chakrasali, R L; SDM College of Engg.&Tech., Dharwad,Sheelavant, V.R.,Nagaraja, H.N. |
5 RNN Based Rotor Flux and Speed Estimation of Induction Motor por Purwahyudi, Bambang | 10 Regeneration of ZVS converter with Resonant inductor por Prasad, J.Sivavara,Babu, Ch.Sai,Obelesh, Y.P. |