Título: Predicting Effect of Pressure, Shaft Velocity and Surface Finish on Depth of Wear of Lining Thickness of Engine Bushing by Experimentation
Autores: Chikalthankar, Sanjay; Department of Mechanical Engineering, Government College of Engineering, Aurangabad
Nandedkar, V. M.; Department of Production Engineering, SGGS Institute of Engineering and Technology, Nanded
Fecha: 2011-04-01
Publicador: Indian journal of science and technology
Fuente:
Tipo: info:eu-repo/semantics/article
info:eu-repo/semantics/publishedVersion
Peer-reviewed Article
Tema: Science; Technology
Crank Shaft Bush, Test Rig, Depth of Wear, Lining Thickness, Surface Roughness
Descripción: Hydrodynamic Cu-Pb-Sn material journal bearings are widely used in automobile and industrial application because of its simplicity, efficiency and low cost. The bearing is often subjected to many stops and starts with unknown load cycles. During this transient period, friction is high and bushes become progressively worn-out, thus inducting certain disabilities. The bushes are provided with a lining of Cu-Pb-Sn material which is found in the range of 450 to 600 micron. The bearing designers are not provided the attention toward this dimension as in practice the failure of bushes observed by seizer, scoring, pitting, cavitations, loss of Babbitt due to high fatigue loads etc. The total depth of wear of healthy journal bearing is observed 150 to 180 micron up to 40000 kms run. The aim of present experimental work is to determine the effect of variable load, sliding velocity of shaft and deterministic surface roughness (Ra) of lining material on sliding wear behaviour and depth of wear of lining thickness(dw) of Cu-Pb-Sn material bush, which is widely used as bush material in automobile engine. The highest temperature zone was determined and the bush samples are marked circumferentially as a, b, c, d, e, f, g in front side and a', b', c', d', e', f', g' rear side in that region. The relationship between depth of wear of lining thickness (dw) versus load, shaft speed, surface roughness is established by using the experimental results and regression model. The numerical result indicates that the surface roughness is most important bearing characteristics and the combined effect of load, shaft speed and surface roughness on depth of wear of lining material particularly in high temperature zone.
Idioma: Inglés

Artículos similares:

Generalized Robust Statistics Method for Estimating Average Length of Stay in Hospitals por Senthilkumar, B.; National Institute of Epidemiology, Ayyapakkam, Chennai – 600 077,Ramakrishnan, R.; National Institute of Epidemiology, Ayyapakkam, Chennai – 600 077
Route Efficient on Demand Multicast Routing Protocol with Stability Link for MANETs por Rajendiran, M.; Department of Master of Computer Applications, Panimalar Engineering College, Chennai -600123,Srivatsa, S. K.; Department of Computer Science and Engineering, Sathyabama University, Chennai- 600119
Investigation of Potential Molecular Markers and Approaches to Characterize and Isolate Spermatogonial Stem Cells in the Nile Tilapia (Oreochromis niloticus) por Lacerda, S. M. S. N.; Department of Morphology, Federal University of Minas Gerais, Belo Horizonte-MG, 31270-90,Costa, G. M. J.; Department of Morphology, Federal University of Minas Gerais, Belo Horizonte-MG, 31270-90,Campos Jr., P. H. A.; Department of Morphology, Federal University of Minas Gerais, Belo Horizonte-MG, 31270-90,Rezende-Neto, J. V.; Department of Morphology, Federal University of Minas Gerais, Belo Horizonte-MG, 31270-90,Hofmann, M-C.; Department of Veterinary Biosciences, University of Illinois at Urbana-Champaign, Illinois,Franaca, L. R.; Department of Morphology, Federal University of Minas Gerais, Belo Horizonte-MG, 31270-90
Seaweed Extracts Control the Leaf Spot Disease of the Medicinal Plant Gymnema Sylvestre por Kumar, Chinnadurai Sreenath; Centre for Advanced Studies in Botany, University of Madras, Guindy Campus, Chennai - 600 025,Sarada, Dronamraju V. L.; Centre for Advanced Studies in Botany, University of Madras, Guindy Campus, Chennai - 600 025,Rengasamy, Ramasamy; Centre for Advanced Studies in Botany, University of Madras, Guindy Campus, Chennai - 600 025
Investigation of the Concentration Goodness for some Liquid Drugs Using Light Angular Scattering por Al-Muslet, Nafie A.; Department of laser systems – Institute of laser - Sudan University of Science and Technology, Republic of Sudan – Khartoum, P. O. Box (407),Yosif, Rasha I.; Department of Physics, College of Science and Technology, Omdurman Islamic University, Sudan – Omdurman, P.O. Box 385,Ahmed, Mubarak M.; Department of laser systems – Institute of laser - Sudan University of Science and Technology, Republic of Sudan – Khartoum, P. O. Box (407)
Categorization of Respiratory Signal using ANN and SVM based on Feature Extraction Algorithm por Jayasri, T.; Embedded Systems, School of Computing, SASTRA University, Thanjavur, TamilNadu,,Hemalatha, M.; School of Computing, SASTRA University, Thanjavur, TamilNadu
Synthesis and Spectral Investigation of some Zn (II), Hg (II), Co (II) and Cu (II) Schiff Base Complexes por Rahmani, A.; Department of Chemistry, Firoozabad Branch, Islamic Azad University, Firoozabad,Mahmoodabadi, E.; Department of Chemistry, Firoozabad Branch, Islamic Azad University, Firoozabad,Heidari, B.; Department of Chemistry, Firoozabad Branch, Islamic Azad University, Firoozabad,Montazerozohori, M.; Department of Basic Sciences, Yasouj Branch, Islamic Azad University, Yasouj,Joohari, S.; Department of Basic Sciences, Yasouj Branch, Islamic Azad University, Yasouj
Vibrations of Biaxially Tensioned-embedded Nanoplates for Nanoparticle Delivery por Kiani, Keivan; Department of Civil Engineering, Islamic Azad University, Chalous Branch, Chalous
In Vitro Propagation of Bacopa monnieri L. - a Multipurpose Medicinal Plant por Vijayakumar, M.; Dept. of Biotechnology, Vinayaka Mission University, Salem - 636 308, TN,Vijayakumar, R.; Research Dept. of Microbiology, Bharathidasan University College for Women, Orathanadu – 614 625, TN,Stephen, R.; Dept. of Botany, Government Arts College, Ariyalur – 621 713, TN
10 
Tao-Mason Equation of State for Refractory Metals por Yousefi, Fakhri; Department of Chemistry, Yasouj University, Yasouj, 75914-353,Kaveh, Meysam; Department of Chemistry, Yasouj University, Yasouj, 75914-353